Coconut Rum Cake

Soo I'm pretty sure that the only way...

...the only way to make a cake I love even MORE than regular coconut cake is to add rum! I infused these cake layers with Malibu Coconut rum and the result was AMAZING!

Coconut cake layers frosted with coconut frosting, infused with coconut rum and topped with a candy melt drip, martini glass, and a sprinkle of coconut! Recipes below!

(Disclosure: As a way to keep my kitchen stocked with butter, sugar, and flour I am a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for me to earn a commission by linking to Amazon.com and affiliated sites.
My posts often contain affiliate links. If you click a link and make a purchase, I may receive a commission at no extra cost to you!) 


Coconut Rum Cake Layers: 
First note – you have options here!
You can sub in your favorite coconut cake recipe, you can use my Favorite Vanilla Cake recipe and sub the vanilla extract out for coconut and add some rum, OR – you can you can do what I did and ‘bakery-level-up’ a couple of boxed cake mixes!

To make the cake layers in the pictures, I used
- 2 coconut cake mixes
- to make them taste richer, I replaced the combined 1 cup of oil the mixes called for with 1 cup unsalted butter (or 2 sticks, melted & cooled)
- total of 7 eggs,
- replaced the 2 cups of water with 2 cups of buttermilk, (room temperature) and
- 2 tablespoons of coconut extract!

Preheat oven to 350°F. Line four 7 inch pans (for taller layers) or three 8-inch cake pans with parchment rounds, and /or grease with non-stick or baker’s floured cooking spray.

Mix together all wet ingredients (butter, eggs, buttermilk, and extract) in a large bowl with a wire whisk. Blend in cake mixes for 30 seconds, and then beat with a wire whisk or hand mixes for 2 minutes until well combined. 
Divide batter evenly between the prepared cake pans (I find a kitchen scale helpful for this part). This guarantees your layers will bake to be the same height.

Bake for 35-37 minutes if using 8-inch pans, or 37-38 minutes for 7-inch cake pans (or until a toothpick comes out clean). Allow cake layers to cool for 10-15 minutes on a wire cooling rack before removing from pans – it helps to run an offset spatula or knife around the perimeter of the pan first. Cool completely before frosting. Set in the fridge or freezer to accelerate the cooling process if desired.

Once the layers have fully cooled, the caramelized bits can be trimmed from the sides / top of the cake using a serrated knife if desired. Be sure the layers are completely cooled or chilled before trimming. If you try to trim the layers while they’re still warm, they will crumble apart.
This is a great time to make your frosting!

Cream Cheese Buttercream Frosting:
8 oz (one package) cream cheese, softened
16 Tablespoons (two sticks) butter, softened
6-7 c powdered sugar 
2-4 Tablespoons milk
2 tablespoons of coconut extract
1/4 t. salt (if using unsalted butter)
Beat together softened cream cheese and butter; slowly add in powdered sugar alternating with milk until frosting reaches desired consistency. Add vanilla and salt if needed and beat until well combined.

Additional Supplies/Equipment:
- 1 8- or 10 -inch cardboard cake circle (I prefer Wilton’s center-punched circles)
- 3-5 oz. of coconut rum (I used Malibu Coconut Rum)
- Measuring cup or jigger (I used one from my Nau Mixology set)
- squeeze bottle or piping bag for the cake drip (you can also use a spoon if you’d rather)
- Cake leveler, cake turntable, large offset spatula, and pastry cutter/bench scraper - not all 100% necessary but incredibly helpful! (Here’s a link to the cake turntable I use)
- Martini glass – you can use a real martini glass OR a plastic one!

- Small offset spatula to smooth the cake drip on top of the cake
- Candy melts for cake drip (recipe below)
- Sprinkle of shredded coconut (for decorating)

Once your cakes are cool, level them (if needed/desired). This can be done with a cake leveler or a large serrated knife and a ruler.

Place a smear of frosting on your cake circle (to keep the cake from sliding while you decorate it) and center your first cake layer in the center of the circle.
With a measuring cup or a jigger (I used one from my Nau Mixology set), infuse each cake layer with about 30-45mLs (1 -1.5 oz.) of coconut rum. Let sit for a minute or two to let it soak into the cake layers.
Spread the first layer with frosting. Add your next cake layer on top, and repeat the process with your remaining cake layers.  

Now you're ready to crumb-coat. If you're unfamiliar with crumb-coating, it's just what it sounds like – spreading a thin layer of frosting over the entire outside of the cake to keep crumbs out of your final layer.
Once your crumb coat has set (this takes about 5-10 minutes in the fridge), add your final layer of frosting and smooth. I like to use an offset spatula and bench scraper for this part, and I made the frosting layer thin enough to let the cake layers show through a bit for a ‘semi-naked’ cake style.
Once your cake is covered, place it into the fridge or freezer to set the frosting.

 This is a great time to make your candy melt drip(s)!

Candy Melt Drip:
- 6 oz white candy melts (I use the Wilton brand Bright White)
- 3 ¾ Tablespoons heavy whipping cream (the brand I usually use comes from Costco and is incredibly thick; you may need a bit less depending on the thickness of your heavy cream!)
(This recipe is very similar to my favorite white chocolate ganache recipe – you’re basically using candy melts instead of white chocolate to make a very similar drip ganache. I prefer this drip when I want bright colors that aren’t tinted yellow from the white chocolate!)
Place heavy cream and candy melts in a microwave-safe bowl, and microwave on 50% power in 30-second intervals until smooth, stirring in between.

I usually find a squeeze bottle or piping bag work the best for this drip when you first start working with it, but I also sometimes use a spoon!  

When your candy melt mix has cooled to a moderate temperature – it should feel slightly warm and still be fairly liquid – transfer it to a squeeze bottle or piping or small ziplock bag – or get your spoon ready!
Slowly drizzle candy melt ganache around the upper edge of your cake, pausing every inch or so to let more fall in a drip down the side of the cake. Pour some of the remaining candy melt mix over the cake, and smooth any gaps or bumpy spots with a small offset spatula. Place the cake into the refrigerator to set the drips!

Rim your martini glass with a bit of candy melt drip mix, and add a bit of shredded coconut to the rim. Invert the glass, and press it upside-down at an angle into the top of the cake, far enough for it to stay in place with the support of the cake layers.
Add a sprinkle of shredded coconut around the glass – and you’re done! Cut in and enjoy!  

Make this recipe? Let me know how it went - or find me on Pinterest or on Instagram and tag @IntensiveCakeUnit in your photo!

Leave a Comment

Your email address will not be published. Required fields are marked *